UV Protection Over Nonslip Epoxy
-
Glice227
- Rare Poster
- Posts: 18
- Joined: Sat Dec 10, 2016 2:58 am
- Local Beach: Lake St Francis
- Gear: Flysurfers, Clouds, Celeritas, Monk, Hydrofoils
- Brand Affiliation: None
- Has thanked: 13 times
- Been thanked: 0
UV Protection Over Nonslip Epoxy
Hi, I am at the finishing stages of my homebuilt board, breather cloth finish is used on the epoxy deck for Nonslip, it is not very rough but works surprisingly well. If I coat this surface with UV protectant varnish will it get slippery? Thanks.
-
TomW
- Very Frequent Poster
- Posts: 3585
- Joined: Wed Oct 05, 2005 6:43 pm
- Kiting since: 2001
- Local Beach: Vejbystrand, Lomma
- Gear: TW Surfboards hydrofoil board 110
Gong Veloce M, 100cm carbon mast
Ozone Hyperlink V1 7m
Hyperlink V2 9m, 13m
Concept Air Wave 4,5m - Brand Affiliation: None
- Location: Sweden
- Has thanked: 53 times
- Been thanked: 193 times
Re: UV Protection Over Nonslip Epoxy
Don't know for sure, but I bet it will. Most modern epoxies have some uv resistance, so I wouldn't be too concerned.
Who is online
Users browsing this forum: Bradford and 398 guests