Contact   Imprint   Advertising   Guidelines

North Speedster Foil. What type of screw... ?

A forum dedicated to Hydrofoil riders


boubou
Rare Poster
Posts: 8
Joined: Thu Oct 30, 2014 4:03 am
Kiting since: 2012
Local Beach: FWT
Gear: Octane 7
RPM. 10
Key. 13
Contra. 17
LF board
Brand Affiliation: None

North Speedster Foil. What type of screw... ?

Postby boubou » Mon Nov 12, 2018 8:07 pm

The original screw are to long for the rear wing, little known issue by North but just found out

What lenght are we to get

Currently using M6 x 30
What’s the treads pitch...

Tks

CCollins
Rare Poster
Posts: 5
Joined: Sun Jun 03, 2018 8:14 am
Kiting since: 4
Local Beach: Alcudia, Es trenc, Deltebro
Favorite Beaches: Sal, Peniche, Obidos, IJmuiden
Style: Mostly waves
Gear: Ocean Rodeo, Cabrinha, North
Brand Affiliation: None

Re: North Speedster Foil. What type of screw....???

Postby CCollins » Mon Nov 12, 2018 9:45 pm

Hi,

Mine were too long as well. I got M6x30, and changed them to Allen head as well. No problems at all now.

3InletsWindsports
Frequent Poster
Posts: 356
Joined: Wed Nov 18, 2015 7:52 am
Kiting since: 2001
Local Beach: Shallow Inlet, Corner Inlet, Andersons inlet.
Favorite Beaches: Shallow Inlet, Point Danger.
Style: freeride
Gear: Zeeko
Brand Affiliation: Zeeko importer in Australia

Re: North Speedster Foil. What type of screw... ?

Postby 3InletsWindsports » Tue Nov 13, 2018 2:11 am

Screws usually are in 5mm increments
But if you currently have, say, 10mm thread engagement then dropping 5mm is 50%


Return to “Hydrofoil”

Who is online

Users browsing this forum: No registered users and 5 guests