I have replaced the speed system bridles and pullies on my chrono v1. By the time the mixer is out the speed system lines needs changing anyway. Simply buy or make another set. I'm expecting to replace the speed system every year. I could push it out longer. But i'm jumping to leg breaking heights on land. A speed system failure at height = broken legs probably.foilholio wrote:I am almost certain the rings can slip. Also when adjustments are made they always tighten and extend further after use. So to get alignment, guessing them a bit shorter is necessary and or trying by hand to tighten them a lot is another.
On the chrono if through some miracle those orbit don't get sand in them they will reduce the pulley line shrink. Maybe also ozone doesn't prestretch the pulley line and or possibly installs it slightly longer than spec? Their use of thin bridles will reduce the likelihood of them shrinking. There is an adjustment for Z on ozone mixers. Z is the most effectual on the kites behavior. The short length B pulley line looks like it will limit B. Being shorter should also reduce it shrinking.
Users browsing this forum: No registered users and 8 guests