Contact   Imprint   Advertising   Guidelines

R1V2 wing sides collapsing

For all foil kite riders


User avatar
f2020
Rare Poster
Posts: 36
Joined: Tue Feb 23, 2016 11:34 am
Kiting since: 2012
Local Beach: Phuket
Favorite Beaches: Phuket
Style: Kitefoil Performance and freeride
Gear: Taaroa Sword RS and Taaroa Sword2
Ozone R1V2 15M
Cabrinhas Switchblade 6,8,9,10,12M
Brand Affiliation: NONE

R1V2 wing sides collapsing

Postby f2020 » Fri Jun 02, 2017 1:53 pm

I just got a brand new R1V2 15M and the wing sides don't seem to inflate properly after launching the kite. When the kite is up in the air the sides keep collapsing. Any similar experiences? Any advises to fix this problem? Thank you.

User avatar
Kamikuza
Very Frequent Poster
Posts: 5385
Joined: Fri Jan 09, 2009 4:49 am
Local Beach: Sabae Beach
Favorite Beaches: Ol' Stinky
Gear: This, that, the other

Re: R1V2 wing sides collapsing

Postby Kamikuza » Fri Jun 02, 2017 2:48 pm

Reach up and pull the steering lines, give it a good jiggle side to side.

Mossy 757
Very Frequent Poster
Posts: 1172
Joined: Fri Sep 11, 2015 5:10 pm
Kiting since: 2013
Local Beach: First Landing State Park, Virginia Beach Oceanfront
Style: Kitefoil
Gear: Delta Hydrofoil and board. Cabrinha Velocity 9m, Flysurfer Sonic2 11m, Elf Joker-7 15m

Re: R1V2 wing sides collapsing

Postby Mossy 757 » Fri Jun 02, 2017 8:44 pm

I'm sorry if this seems offensive, but do you have any foil kite experience or is this your first time?

If you're a seasoned foil kiter reporting this issue it's like that your bridle or mixer needs a quick tuning check. If you're just learning for the first time, it's a user issue...oversheet the kite and inflate it vertically at the edge of the window like shown in this video:

phpBB [video]


If you're reusing an older bar with the kite and haven't checked your bar tune, you should also do so to verify all 4 of your lines are equal length when the trimmer is fully released and the bar is held against the chicken loop. Many foil kiters, myself included, tune their front lines to be a bit longer than their rear lines so that at full power you can oversheet the kite and slow it down and/or prevent it from overflying the window. 1-1.5" should be a sufficient amount of backstall to induce in the bar.

socommk23
Frequent Poster
Posts: 440
Joined: Mon Oct 03, 2016 10:05 pm
Kiting since: 2001
Local Beach: Hill head
Favorite Beaches: Brean. Uphill. Pembrey. Hill head. Meon shore
Style: Keeping the kite dry....hopefully
Gear: F.one diablo 15, 11 and 8m . Pansh aurora2 15m. Pansh sprints and firsts and Adams and flux .
Brand Affiliation: None

Re: R1V2 wing sides collapsing

Postby socommk23 » Fri Jun 02, 2017 9:43 pm

To be fair the ozone foil kites are know to do this. Its a case of flying the kite right alot of the time. These high aspect race kites dont like to sit around doing nothing. Though some do better than others. Sonics can fold on launch but once inflated they are very stable. Ive not seen Fone diablos do it at all.

User avatar
K-Roy
Medium Poster
Posts: 132
Joined: Tue Jan 27, 2015 5:42 pm
Kiting since: 2013
Local Beach: Lake Balaton
Favorite Beaches: Cumbuco to Jeri
Style: strapless SB & strapless FB
Gear: Fone Bandit and Diablo V.1
FW Vader, OR Duke, Fone foil
Brand Affiliation: None

Re: R1V2 wing sides collapsing

Postby K-Roy » Fri Jun 02, 2017 10:13 pm

my V1 Diablo's tip folds in at launch some times. I do what Kami said, pull steering lines hard from side to side a few times and its good to go...

norcom
Frequent Poster
Posts: 291
Joined: Mon Jun 23, 2008 11:51 pm
Kiting since: 0
Style: waves
Gear: Too much to list these days. Currently mostly a v3 Cabo's and Spleene Zone fan
Location: Florida

Re: R1V2 wing sides collapsing

Postby norcom » Fri Jun 02, 2017 10:44 pm

Had the exact same issue on my R1v1 when I was first learning to fly it. As other said, pull the rear lines with some force or shake the bar hard left and right.

User avatar
gmb13
Very Frequent Poster
Posts: 1114
Joined: Wed Sep 12, 2007 10:19 am
Kiting since: 1999
Local Beach: Flag Beach, Fuerteventura
Style: Everything
Gear: Ozone, Axis, Moses, Zeeko, Firewire, SBS
Brand Affiliation: Foiling Basics, The Boardroom Fuerteventura, Ozone, Axiskiteboarding,Schwerelosigkite, Triggernaut,
Location: Fuerteventura
Contact:

Re: R1V2 wing sides collapsing

Postby gmb13 » Sat Jun 03, 2017 11:54 am

If it's a new kite and you are launching it properly, the V2 should not be collapsing the wingtips after it's fully inflated.

If the tips still collapse after the kite is fully inflated, then extend the KR1 about 2cm. Do this by moving the Knot holding KR1 (yellow lines) up towards the kite by 2cm. This should stabilise the tips. However you should not need to do this on a brand new kite.

--
Gunnar

User avatar
mgs
Rare Poster
Posts: 49
Joined: Wed Sep 03, 2003 10:55 am
Kiting since: 2000
Style: Cruising/Skimboarding/Flat Water/Waves
Gear: Ozone Chrono V1 18m/12m/9m
Zap Skimboard & Twin Tip
Location: England

Re: R1V2 wing sides collapsing

Postby mgs » Sat Jun 03, 2017 9:52 pm

Pre-inflation really helps before launching.
Remember these are high performance closed call foils with many cells that need to be inflated, just a question of practice. Pulling the brake line handle when the kite is in flight will help to inflate the wing tips but does requires subtle inputs. Practicing in lighter winds first will help.
All the best.
http://ozonekites.com/images/uploads/pr ... al-ENG.pdf

ozchrisb
Frequent Poster
Posts: 289
Joined: Sat Dec 29, 2012 2:59 am
Kiting since: 1999
Brand Affiliation: None

Re: R1V2 wing sides collapsing

Postby ozchrisb » Mon Jun 05, 2017 6:51 pm

If the kite's not fully inflated and the tips flop in, that's expected. Use a lot of brake to launch, or pre inflate.


Return to “Foil Kites”

Who is online

Users browsing this forum: No registered users and 2 guests

cron