So came upon a VERY slightly used Pansh Aurora 2 12m2 UL from a friend for and unbeatable price.
On the beach in about 6 knots we were impressed both with turning speed, radius , power, and general flight.
I have done way to many measures and marks so can tune and as have read loads kinda knew it might be a "project" to get it tuned.
Also interesting that another local has exactly same kite.
So first KBHF session in about 8 knots.
First kite down turn flying jibe found kite collapsed, seems both tips AND L E!
Was able after board on H20 to get it back and took off again.
Did many front and back water start loops and even some without, feeling the kite more and more
BUT,
if did not pay close attention to bar trim when doing kite down turns it collapsed many more times.
Funny that in up turns had no problem!
generally felt Ok but sure need to improve!
So as I have made super easy AoA and camber adjusters what do you suggest?
We did note that my C mixer was 4 cm longer than the other brand new stock spec.
My first inclination is to "set it back" in the window, increase AoA, by progressively shortening B then C then Z as lecca lecca shows here,
http://www.lecca-lecca.com/#layer_5
Other ideas plaeas?
R H