Contact   Imprint   Advertising   Guidelines

Poor man's CNC

Here you can exchange your experience and datas about your home build boards
DartBoard
Medium Poster
Posts: 61
Joined: Sun Nov 27, 2016 11:57 am
Local Beach: Longreef in Sydney, NSW
Favorite Beaches: Longreef, Yorkeys Knob
Style: Surf Foil
Gear: RPMs, Switch, Homemade TT, Homemade Foils
Brand Affiliation: None
Has thanked: 0
Been thanked: 0

Re: Poor man's CNC

Postby DartBoard » Sat Jan 07, 2017 1:47 pm

Very cool !

DartBoard
Medium Poster
Posts: 61
Joined: Sun Nov 27, 2016 11:57 am
Local Beach: Longreef in Sydney, NSW
Favorite Beaches: Longreef, Yorkeys Knob
Style: Surf Foil
Gear: RPMs, Switch, Homemade TT, Homemade Foils
Brand Affiliation: None
Has thanked: 0
Been thanked: 0

Re: Poor man's CNC - actual CNC

Postby DartBoard » Fri Jan 13, 2017 10:59 am

I came this design for a home build CNC that is really well thought through and designed around it being made in a home workshop without precision tools. They have open sourced all the hardware designs too !

http://goodenoughcnc.eu/

TomW
Very Frequent Poster
Posts: 3585
Joined: Wed Oct 05, 2005 6:43 pm
Kiting since: 2001
Local Beach: Vejbystrand, Lomma
Gear: TW Surfboards hydrofoil board 110
Gong Veloce M, 100cm carbon mast
Ozone Hyperlink V1 7m
Hyperlink V2 9m, 13m
Concept Air Wave 4,5m
Brand Affiliation: None
Location: Sweden
Has thanked: 53 times
Been thanked: 193 times

Re: Poor man's CNC

Postby TomW » Fri Jan 13, 2017 8:03 pm

There's the X carve by Inventables. The Handibot and other cnc by Shopbot.

DartBoard
Medium Poster
Posts: 61
Joined: Sun Nov 27, 2016 11:57 am
Local Beach: Longreef in Sydney, NSW
Favorite Beaches: Longreef, Yorkeys Knob
Style: Surf Foil
Gear: RPMs, Switch, Homemade TT, Homemade Foils
Brand Affiliation: None
Has thanked: 0
Been thanked: 0

Re: Poor man's CNC

Postby DartBoard » Sun Jan 15, 2017 8:51 am

TomW wrote:There's the X carve by Inventables. The Handibot and other cnc by Shopbot.
I think the ones you mentioned are all solely commercial products. The Goodenoughcnc is completely opensource (hardware and software) so you can built it from scratch and customize it. There are a lot of designs out there but this one stood out for me because the design assumes you don't have precision tools to drill and mill so builds adjusters into it.

https://goodenoughcnc-hybrid-cnc.readme.io/docs


Return to “Gear Builders”

Who is online

Users browsing this forum: No registered users and 55 guests