Contact   Imprint   Advertising   Guidelines

Mounting a Foil on an old Twin Tip

Forum for hydrofoil builders.


reyrivera
Medium Poster
Posts: 60
Joined: Fri Jan 30, 2009 11:18 pm
Kiting since: 2005
Local Beach: Santa Cruz, CA.
Alameda, CA.
Pittsburgh, CA.
Style: Strapless boards
Gear: Caution Kites
Home made C kites
Brand Affiliation: None
Location: Northern California

Mounting a Foil on an old Twin Tip

Postby reyrivera » Thu Apr 06, 2017 5:14 am

So, I'm a novice foil boarder, almost zero experience water time. Just got my LF foil, still waiting for my fish board.

Meanwhile, to get me started in the water, I was thinking of attaching an old 135 BOA twin tip on my foil, maybe about 10 inches from the back? Also, add additional non skid foam on the top alongside surf footstraps?

Anybody have experience on this setup. And is it a good idea for a beginner to try this setup?

FoilOnTwinTip.1.png

windmaker
Very Frequent Poster
Posts: 1263
Joined: Sun Jun 15, 2003 8:48 am
Kiting since: 1999
Local Beach: .
Style: Strapless surf and foil
Gear: F-One kites/ HB surf/ Taaroa foil/ Manera
Brand Affiliation: F-One
Contact:

Re: Mounting a Foil on an old Twin Tip

Postby windmaker » Thu Apr 06, 2017 6:22 am

You can try, but I wouldn't recommend it. As a beginner volume and a good rocker are valuable but most important a TT is not stiff enough for foilboarding. Even for an experienced rider you want 0 flex in a foilboard board.

Blackrat
Frequent Poster
Posts: 226
Joined: Thu Mar 12, 2015 4:55 pm
Kiting since: 2002
Local Beach: Knysna, South Africa
Gear: old
Brand Affiliation: None
Location: Knysna South Africa

Re: Mounting a Foil on an old Twin Tip

Postby Blackrat » Thu Apr 06, 2017 8:39 pm

I highly advise you not to ...

I have a mate who fitted one to a TT and I think it's put him off foiling .. I've tried it myself and it's not easy

Rather get a big surfboard and chop 200-300 mm off the nose

bigtone667
Frequent Poster
Posts: 270
Joined: Mon Jul 20, 2015 7:24 am
Kiting since: 2013
Local Beach: Umina Beach
Favorite Beaches: Umina Beach, Birdies Beach, Lake Munmorah
Style: surf, foiling, lawn mowing
Gear: BRM Cloud C2's, .5's, D's and few old BWS kites

Slingshot Skim Boards, North Surfboards, BRM Paipo, Shinn El Stubbo/Shinnster/Jackson, Firewire Boards, CrazyFly Doors, Zeeko Carver/Spitfire Foils
Brand Affiliation: None

Re: Mounting a Foil on an old Twin Tip

Postby bigtone667 » Fri Apr 07, 2017 1:26 am

I did it and it worked fine. The primary issue I had was the sandwich construction of the board required re-reinforcement (Shinn Style).

I used a crazyfly lightwind door (150x50). I attached a 600x250x22 block of pine to the bottom of the TT, and used 8mm bolts with HUGE washers (top and bottom) to secure the board.
I then used 8mm bolts + HUGE washers through the block of pine and TT to attach the foil.

Works really well as a light wind board/foil with only a small amount of swing weight.

I have smashed into weed and sand numerous times without any issues.

tegirinenashi
Frequent Poster
Posts: 453
Joined: Wed Aug 27, 2014 3:29 am
Kiting since: 2003
Local Beach: 3rd Ave
Gear: Cabrinha CO2 9.5m, Naish x2 14m, Litewave 161
Brand Affiliation: None

Re: Mounting a Foil on an old Twin Tip

Postby tegirinenashi » Fri Apr 07, 2017 6:49 pm

I was thinking going the same route (choosing O'Brian 137 wakeboard) but decided not to. Smaller less buoyant board means harder water start and greater risk loosing the whole setup when separated from the board. Relatively sharp rails make the whole thing a bitch to carry along.

juandesooka
Very Frequent Poster
Posts: 682
Joined: Wed Aug 29, 2012 8:05 pm
Kiting since: 2011
Local Beach: Sooke, BC, Canada
Gear: BWS / Ocean Rodeo / Stringy Foil
Brand Affiliation: None

Re: Mounting a Foil on an old Twin Tip

Postby juandesooka » Fri Apr 07, 2017 6:56 pm

I expect you'd figure out how to use it, but sounds like it might not be easiest option from what people are saying about flex.

My concern would be buoyancy. The LF set up is not light and doesn't float ... when you wipe out, it may sink without board flotation (!) or at best may be neutral buoyant, making it hard to find in choppy waters. I considered attaching my rig to a wood paipo, but was advised not to for this reason.

Or fill the mast with waterproof spray foam, kinda like a Boston Whaler "unsinkable boat" option. :-)

User avatar
downunder
Very Frequent Poster
Posts: 1057
Joined: Mon Jul 01, 2013 7:16 am
Kiting since: 1970
Gear: building my own
Brand Affiliation: None
Location: Perth, Australia

Re: Mounting a Foil on an old Twin Tip

Postby downunder » Wed Apr 12, 2017 3:14 am

I would say go for it.

There is almost absolutely no difference in construction with TT and ie Cab Double Agent. None. The Agent flexes, has similar buoyancy to a TT etc. etc.

What Agent has tho are more SS inserts for the mast position. And a way more width and tip rocker. Minor things :)


Return to “Hydrofoil Builders”

Who is online

Users browsing this forum: No registered users and 2 guests

cron