As an admitted lawnmower, why would you give advice on the mechanics of unhooking ?lawnmower wrote:Making the CL bigger has implications...
The bar will be that much farther from your body. Your normal riding position for arms will necessarily change if you don't make other adjustments, i.e. shorten the center lines via depower. Problem with that is you'll be back to full-power where your arms normally are, and you'll lose the ability to depower as much as before.
You'll need a new longer donkey-dick too. Those things are cut just right. If too long, they are hard to get in and out and may poke your belly. Too short they'll pop out when you least expect. Me thinks one of the reasons for small CLs is precisely to keep the DD short so it doesn't poke you.
My 2011 Naish cl/dd are a perfect combination - when it is under full load the dd is just right, hasn't ever popped out unexpectedly.
To the OP : The Naish chickenloop will actually be a lot easier than you'd imagine to rebuild quite a bit larger. There will be a bit of work involved, several tiny screws to remove and remember where they go for reassembly, and a bit of splicing, which might be new territory but its actually super easy.
The biggest problem will probably be sourcing the polyurethane covering over the spectra inner, if you can get a slightly longer section of that, and then disassemble your current loop, you should be able to build one just by copying. Some really great splicing resources can be found on the samson rope website. probably only take a couple hours.
That being said you could just go buy a pimp new airush bar