1600cm2 is 250 sq inches ! wow thats huge man ! i think its just gonna be too much drag

on such large wings i think its important to go with high aspect or your wing is too thick causing alot of drag

The welds didn't fail, but rather the heat generated from the welds will cause the stainless to harden

It's stainless steel , it's doesn't fatigue well at all ....

As Gunnar says , wrapping with biax carbon will give the piece tortional strength , essential for a nice stiff fuselage

High lift does not make a wing easier or less easier to ride It's more about stability , speed and stall A slow stable foil is much easier to learn to ride than a fast one What makes a foil stable Flat wings , longer and thicker chord slows it down and doesn't stall easily What makes a foil fast Thi...

Also centimeters are for preschoolers and civil engineering - you're not riding a brick nor a drywall. As a mechanical engineer I was taught to measure in millimeters. Who cares though... But two words: Robertson screwdriver Mwahahahaha ... I'd love to know who came up with cm and boink him on the ...

Try figure this one out

Banga will be releasing a new foil next year
Are there a minimum amount that have to be produced to be registered ?

Love your builds man ! Why two layers veneer ? And 4oz fabric glass is just adding weight , it won't get to be loaded as the carbon will load up before the glass Surely 1 layer 200g on the bias is enough ? That's what I do with a 100mm wide 300gsm carbon uni running down the length Never had a board...

hey guys

i need a smaller kite and found this .. anyone tried it for foiling ? i ride my 9RRD the most, but sometimes a bit over powered

thoughts experiances ?

https://www.thekiteboarder.com/2013/01/ ... ahoona-v5/