Forum for kitesurfers
-
Rojbrown
- Medium Poster
- Posts: 66
- Joined: Sat Apr 09, 2011 3:31 am
- Kiting since: 2009
- Weight: 190lbs
- Local Beach: Lake Mojave boat launch
- Favorite Beaches: Lake Mohave AZ
SPI
Union Island
- Style: Intermediate surf/beginner foil
- Gear: Switch Helium 8/12/16
Hyperlink V1 12
- Brand Affiliation: None
-
Has thanked:
53 times
-
Been thanked:
12 times
Postby Rojbrown » Sun Jan 20, 2019 5:55 am
There may be a discussion on this somewhere but I haven't found it. What is the best tape/material to refurbish a control bar grip? Thanks!
-
iriejohn
- Very Frequent Poster
- Posts: 2618
- Joined: Fri Dec 18, 2015 11:04 pm
- Weight: 80kg, 1.78m
- Local Beach: West & East Wittering (UK South Coast)
- Style: Make it up as I go along
- Gear: Bars, Kites
Twintips, Directional
- Brand Affiliation: None
- Location: Noviomagus Reginorum
-
Has thanked:
554 times
-
Been thanked:
284 times
Postby iriejohn » Sun Jan 20, 2019 7:13 am
-
edt
- Very Frequent Poster
- Posts: 7332
- Joined: Fri Jul 16, 2010 6:27 am
- Kiting since: 2010
- Local Beach: Michigan
- Gear: ride hard, no regrets
-
Has thanked:
533 times
-
Been thanked:
668 times
Postby edt » Sun Jan 20, 2019 2:16 pm
Bicycle super soft foam tape (I can't remember which brand I used) is the best, most comfortable nicest looking replacement. it doesn't stick well enough on its on so you want to do your entire wrap and then after the wrap is done, get some other kind of tape like hockey tape or sail tape and on the ends of the bar tape do a single wrap around the end so it doesn't come undone. Done right it comes out better than your bar originally shipped.
-
Windigo1
- Very Frequent Poster
- Posts: 938
- Joined: Tue Jan 17, 2017 5:57 pm
- Style: Foil foil.. and Old School!
- Gear: Too many to list
- Brand Affiliation: None
-
Has thanked:
63 times
-
Been thanked:
217 times
Postby Windigo1 » Sun Jan 20, 2019 2:37 pm
I built an 80 cm bar for a 22m foil since I could not find one big enough. I used bicycle handlebar foam tape. It worked great and it's very comfy. It started moving around after the initial install so I had to unwind it and put contact cement on the bar and reinstall it. Now it's been solid for a few years. You put some tape at the tip where the foam tape ends. I used hockey tape.
Return to “Kitesurfing”