I ended up pulling out the inner donut with the valve on it and regluing it from the outside. It seems to hold air.
Time will tell how well it holds under heavy use.
If it works then I saved myself buying 3 valves (and waiting for the delivery).
Thanks for all the tips
this is the way to do it
(i done it before with blade kite),
warm a little bit the area(with hair fan),push the valve inside(like u did at the pic),
& then pull it out through the exist hole(it possible),
clean it & glue it from outside,
important to use good glue like bison vinil , put weight & wait few hours