arr no,one problem with re-using the thick red line, splicing it and adding a new lower section of sk99 spliced end to marry up with the red splice,it allKitemenn wrote: ↑Thu Aug 20, 2020 11:32 am
I think the brilliance of your hack is that the small section where the wear takes place can be replaced frequently and that the longer piece can stay in place (where there is way less wear).
Anyway I still got the Duotone lower front lines and will keep an eye on the wear, but might be using your hack to either shorten the red line (cut out the section of the wear) and then making these replacement lines as you mentioned.
sounds good, however-
the red line is just too thick, so when you join the new section to it the bump created joining the new splice loops certainly wont pass through the long Pu power line tube, it will jam at the top then the constriction caused by the bar throw stop gizmo on the pu tube, and maybe through the bottom exit hole.
that red line is one long bit of fat problems,