Contact   Imprint   Advertising   Guidelines

Home made blade for snowboard (switchblade)

Here you can exchange your experience and datas about your home build boards
User avatar
Gustas
Rare Poster
Posts: 37
Joined: Mon Jan 03, 2005 1:11 pm
Kiting since: 0
Gear: SS
Brand Affiliation: None
Location: Latvia, Riga
Has thanked: 0
Been thanked: 0

Home made blade for snowboard (switchblade)

Postby Gustas » Tue Dec 08, 2009 11:13 am

Can anyone share some info about dimensions and sizes of the blade and angle?
Thinking about something similar to switchblade
Image
And do I understand correctly that holes for the angle has to be drilled through the snowboard?
Thanks for answers in advance.

gbgreen59
Very Frequent Poster
Posts: 586
Joined: Tue Aug 24, 2004 6:39 pm
Kiting since: 2003
Brand Affiliation: None
Location: Iowa
Has thanked: 0
Been thanked: 0

Re: Home made blade for snowboard (switchblade)

Postby gbgreen59 » Thu Feb 18, 2010 10:25 pm

Hi Gustas,
I own a Switchblade. You are correct that holes are drilled through the base of the snowboard to mount the Switchblade. You must counter sinc the holes so that the screw heads are flush with the bottom of the board. There are people who are very knowledgeable about how to sharpend ice skate blades. I'm not one of them. But, the blade is grooved along the edge as opposed to being a flat edge that is sharp on the corners. Hence, a tool is provided with the Switchblade (top of your picture) to sharpen the blade. The angle bracket is about 30 cm long and is approximately 90 degrees. I have not measured the ange, but it is pretty close to 90 degrees.

marekb
Rare Poster
Posts: 2
Joined: Wed May 21, 2014 11:27 pm
Kiting since: 2000
Local Beach: Ontario
Favorite Beaches: Hawaii, Cuba
Style: Freeride
Gear: Core
Brand Affiliation: None
Has thanked: 0
Been thanked: 0

Re: Home made blade for snowboard (switchblade)

Postby marekb » Sat Jan 12, 2019 9:26 pm

Hi
Would you be willing to provide dimension of the switchblade parts:
The bracket angle length, width of both walls and wall thickness.
The blade length, width and thickness.
What materials the angle bracket and the blade are made from
Thank you
Marek


Return to “Gear Builders”

Who is online

Users browsing this forum: No registered users and 4 guests