Here you can exchange your experience and datas about your home build boards
-
merl
- Very Frequent Poster
- Posts: 760
- Joined: Tue May 15, 2007 8:43 pm
- Kiting since: 1999
- Gear: HF
- Brand Affiliation: None
- Location: Sweden
-
Has thanked:
108 times
-
Been thanked:
113 times
Postby merl » Tue Jun 16, 2020 8:51 pm
What mini tubes are you using for bar ends? See pic of split carbon ones. Obviously they are too thin/weak, but what should I use?
Edit: I researched a bit. The tubes I was using were 9mm outer, 7mm inner pulltruded (all fibers in the same direction). This is obviously going to be prone to split. I will look for a twill fiber tube. I'm thinking 8mm, inner 4mm, but it is hard to find. Is that similar to what is used by others (SK shapes?)?
Edit again: Found some with OK EU postage:
https://www.ebay.co.uk/itm/292480555583
Last edited by
merl on Wed Jun 17, 2020 12:38 pm, edited 3 times in total.
-
merl
- Very Frequent Poster
- Posts: 760
- Joined: Tue May 15, 2007 8:43 pm
- Kiting since: 1999
- Gear: HF
- Brand Affiliation: None
- Location: Sweden
-
Has thanked:
108 times
-
Been thanked:
113 times
Postby merl » Tue Jun 16, 2020 9:06 pm
Removed
Return to “Gear Builders”
Who is online
Users browsing this forum: bohme and 118 guests