Contact   Imprint   Advertising   Guidelines

North track system install

Here you can exchange your experience and datas about your home build boards
Medium Poster
Posts: 94
Joined: Sat Apr 09, 2011 1:33 pm
Local Beach: south coast uk
Brand Affiliation: None
Has thanked: 5 times
Been thanked: 5 times

North track system install

Postby supachip1 » Thu Jan 07, 2021 2:26 am


I have an old spectrum board I use for light wind but can't get the stance the same as my normal board so I wondered if I could router out a track system in it.

I've not checked the thicknesses of the spectrum yet but just wondered if anyone had done this and anytjng I should consider.
Are the Norths re-enforced around that part of the board. The channel is only 1/16th in, any chance of break out?


Rare Poster
Posts: 45
Joined: Wed May 23, 2007 1:18 pm
Local Beach: South of Germany and north east Italy
Style: Freestyle Freeride
Gear: Vegas 10 12 14
Waroo 7
Kahoona 10.5
JN Circus
Nobile Zen Split Hydrofoil
Brand Affiliation: None
Has thanked: 4 times
Been thanked: 2 times

Re: North track system install

Postby dericcio2 » Thu Jan 07, 2021 8:09 am

i have done this on my custom volume board. track self made by 3d printing.( file available in the thread pocket board). laminated over 3x200 glass + 1patchx200 bidiagonal carbon. probably it is overengineered.
tested only for two hours till now andit worked well

Return to “Gear Builders”

Who is online

Users browsing this forum: No registered users and 3 guests