North track system install

[supachip1]

Hi,

I have an old spectrum board I use for light wind but can't get the stance the same as my normal board so I wondered if I could router out a track system in it.

I've not checked the thicknesses of the spectrum yet but just wondered if anyone had done this and anytjng I should consider.
Are the Norths re-enforced around that part of the board. The channel is only 1/16th in, any chance of break out?

Cheers

[dericcio2]

i have done this on my custom volume board. track self made by 3d printing.( file available in the thread pocket board). laminated over 3x200 glass + 1patchx200 bidiagonal carbon. probably it is overengineered.
tested only for two hours till now andit worked well