I have no access to a vacuum pump, so I'll have to do all the lay up old school, by hand.
How many layers can I do at once?
Can I do a layer, let it dry, then add another. Are there any issues with the layers binding together?
Slow or fast catalyst?
Any tips for doing the mast? I'm going clamp the mast, leading edge facing up and to try to wrap the cloth around both sides at the same time. The mast is 15mm at its widest point. Not sure if the leading edge is too sharp a curve for the carbon fiber to bend around without something holding it in place.
Any tips for the wings? I was thinking of doing the same as the mast. I expect I'll only do one or two layers, the front wing is 3 layers of ply making 15mm at the thickest point, the back wing 2 layers of ply making 10mm.
Do you put a gloss coat on?