If it would help, I try to make a video in May/June...
Best way to learn any transition is to have someone who can actually do what you want to learn near you. As different people make different mistakes he can see what you are doing wrong and correct you.tomtom wrote: ↑Fri Apr 19, 2019 10:12 amThis video is one of kind which explain exactly nothing. What it show is clear for anybody who even dare to try. And there is nothing about foot switch which is thing that make that success or fail. So just switch your feet...
Sorry nothing against this video in particular but there are lot of these videos from talented guys who somehow do everything without knowing how. And they have obvious problem to transfer this knowledge to less talented guys /like me/
are those ski boots!?!windmaker wrote: ↑Mon Apr 08, 2019 5:59 amSure, timing with the down loop is harder to get right than with the "tight lines" jibe method but really no big deal, you just need to understand it. Just like someone else said in a previous post as long as you have board speed , all good.Peter_Frank wrote: ↑Sun Apr 07, 2019 5:26 pmwindmaker wrote: ↑Sun Apr 07, 2019 3:10 pm
Used this technique for years (kitefoiling since 2005) it s much easier than the traditional foot swap /down loop method used by racers. Can only be done on a very close reach which often implies a change of direction before each turn and looks a bit clunky or not as fluid. Completely useless on a downwinder as you end up sailing away from your original direction on every turn which is very ... inefficient.
Second this, longer lines, keep lines tensioned before the turn, and kite quite low (not so low that you lose speed though), and turn it up and around while you carve, carve tight, and use the downward path to get kite speed so you keep foiling.
If you use shorter lines, you will probably end up with the kite too low at the end of the carve, thus stop foiling, and you will also lose the good power sweep.
This is the very reason I use 30 m lines on all kites above 10 m2, as this works splendid for me from 8 knots and down.
Sometimes I do a "race jibe" meaning kite up high, carve around and let the kite follow after.
Problem is, if I carve too late, the kite can not downloop and might end up in the water, because of slack lines, and a swim ashore is the result in this wind.
If I carve too early, I might end up not foiling during the carve, as the kite havent picked up power yet when it hasnt picked up speed in the downloop yet.
So for me this is a difficult move actually, and more risky too.
But I can see, when perfected and you keep a lot of speed, it might be the best way to get as low as possible yes - I just havent found the holy grail here yet, OR, my bigger wings are too slow
Windmaker, you are one of the very early pioneers then?
It seems the first experiments was around 2001.
But I first saw a more public video of kitefoils in 2007, where the Mango Carafino board came, awesome and started it all slowly back then, eventhough it was the French who made kitefoils so fast that raceboards died and got extinct in one single year, so now the whole world started foiling and believing in it
Using this technique, on certain occasions I was sailing back and forth relying solely on apparent wind. If for any reason I stopped it would be impossible to waterstart again.
BTW Carafino was already making foils in 2005 .
Users browsing this forum: No registered users and 5 guests