I have to say that after moving from a plate to a box, mounting the foil with just one Torx screw is a luxury I would hate to give up. The plate is in the opposite direction of tool-less.jumptheshark wrote: ↑Fri Jun 07, 2019 12:51 pmWe've almost got standard board mounting accomplished
Unless you use electric screwdriver, one bolt screwed the full length is more work than just sliding 4 already mounted bolts into the plate, and tightening each with quarter turn. I even added foam pads to block the release holes in the middle of the tracks, so that bolts with T-nuts obtain permanent residence in the tracks.jakemoore wrote: ↑Fri Jun 07, 2019 8:03 pmI have to say that after moving from a plate to a box, mounting the foil with just one Torx screw is a luxury I would hate to give up. The plate is in the opposite direction of tool-less.jumptheshark wrote: ↑Fri Jun 07, 2019 12:51 pmWe've almost got standard board mounting accomplished
Understand this, especially if you have to dismount for transport, but on the other hand, I would never give up plate, which on one hand has become the standard and on the other hand enables to setup pressure point on tracks, which would be inaccebtable to give up for me.
Users browsing this forum: blu, rynhardt, SlingshotBM, thewindego and 188 guests