I have water inside one of my masts.
It is a aluminum mast (from Liquid force).
The reason why water is inside is because of the 3 small 'plugs' that covers the wholes sits loose. I manage to take out the biggest of the 3 plugs, however the two small ones are now push back inside the mast..
I think I have the mast reasonable dry.
How can I 'clog' the 3 wholes? Epoxy?
I cannot remove the collar/plate (the connection between board and mast) since the hardware is corroded (the previous owner..!). That you have ease the drying out and maybe removal of the small plugs.
I think the mast will last with no problem, despite a bit of water left.
Will there be any problems if I seal the 3 holes with epoxy?
Any other suggestions?
PICTURES OF MAST