Contact   Imprint   Advertising   Guidelines

Matrixx II Lineplans and line audit XLS tool

For all foil kite riders
lightandfrost
Rare Poster
Posts: 42
Joined: Thu Jul 13, 2017 1:48 am
Local Beach: e
Favorite Beaches: e
Style: onshore waveriding
Gear: v
Brand Affiliation: None
Has thanked: 0
Been thanked: 3 times

Matrixx II Lineplans and line audit XLS tool

Postby lightandfrost » Mon Jul 20, 2020 12:28 pm

Lines on ram-air kites shrink after time. When the kite begins to loose its flight efficiency the line lengths must be corrected. This can be done in three(3) ways which are; 1. Buy a new line set, 2. Stretch the lines back to factory or 3. Add larks head extensions to the lines to restore the length to factory settings.

Light and Frost(L&F) prefer to add larks head extensions to restore the line length. This is because if you stretch the lines they just shorten again while larkshead extensions provide a more lasting repair as there is a limit to how far the lines can shrink. Once done kites rarely require another adjustment.

To correct these lines a lineplan from the manufacturer is required. Then using the lineplan a line audit must be performed and larkshead extensions added as required.

Attached is the lineplan from the makers of the Matrixx II for ALL kite sizes in this model. L&F was asked to assist in the restoration of a 15 meter kite size. To keep track of the corrections L&F has written an XLS spreadsheet which calculates the length of line to cut. Generally this is twice the length required for the adjustment plus 7cm for the knot. The spreadsheet can easily be changed to other kite sizes seen on the lineplan. Just unprotect the XLS file and change the factory lengths.


L&F use 100lb test Dacron fishing line when making larkshead extensions. Suggest you use a cloth tape measure used for sewing not a metal one due to the flexibility of the cloth.

We have done many many line audits. Generally when the trailing edge lines connected directly to the kite shrink approximately 10cm it is time to do the line audit. Normally the most shrinkage is also found on these trailing edge lines.



1. BRIDLE_MATRIXX_II.pdf
2. Matrixx-15-II.xls
Attachments
BRIDLE_MATRIXX_II.pdf
(264.7 KiB) Downloaded 15 times
Matrixx 15 II.xls
(33.5 KiB) Downloaded 11 times

Return to “Foil Kites”

Who is online

Users browsing this forum: No registered users and 5 guests