Contact   Imprint   Advertising   Guidelines

Replace small bridle Peak 4 the right way.

For all foil kite riders
ieism
Rare Poster
Posts: 44
Joined: Sun Jun 21, 2020 8:56 pm
Kiting since: 2018
Gear: Flysurfer Peak 4
Brand Affiliation: None
Has thanked: 10 times
Been thanked: 10 times

Replace small bridle Peak 4 the right way.

Postby ieism » Mon Aug 31, 2020 8:35 pm

So it seems the previous owner replaced the aa1 and A1 line with a non original line. He also managed to swap around the a1, a2, a3 &a4, a5, a6 lines.
I've ordered new lines and measured the smaller lines so they are now correct.

My question is, the a1, a2, a3, are supposed to connect to the A1 without a knot in them. Both sides are loops, but I dont want the 3 lines to the A1 by looping them through themselves because you get an ugly knot. I want the A1 to loop through the 3 lines, like it is on the other side original. But then I'd have to take the AI and also A- main apart and start assembling from the kite to the bar?
Has anyone done this the proper way?
Attachments
Screenshot_20200831-212128_Drive.jpg

Return to “Foil Kites”

Who is online

Users browsing this forum: No registered users and 3 guests