So it seems the previous owner replaced the aa1 and A1 line with a non original line. He also managed to swap around the a1, a2, a3 &a4, a5, a6 lines.
I've ordered new lines and measured the smaller lines so they are now correct.
My question is, the a1, a2, a3, are supposed to connect to the A1 without a knot in them. Both sides are loops, but I dont want the 3 lines to the A1 by looping them through themselves because you get an ugly knot. I want the A1 to loop through the 3 lines, like it is on the other side original. But then I'd have to take the AI and also A- main apart and start assembling from the kite to the bar?
Has anyone done this the proper way?