My 12m Soul was not behaving normally - tips folding in and lack of boost.
Short mixer test results - z-line was 3 cm shorter than a-line.
Long mixer test result - z-line was 12 cm shorter than a-line.
Of course, B and C lines are messed up too, but they are easy to adjust. I need to equalize the a- and z-lines first.
My question:
Should I just extend the z-lines by 12 cm?
Should I shorten the a-lines by 12 cm?
Should I do a combination of the two?
If I do any of these things to make the long mixer test correct, then the short mixer results will have the z-line 8cm too long.
Is that a problem?
There is no way to adjust the difference between the a-line and z-line. This seems to be a design flaw, as the z-line shrinks the most, and the a-line shrinks the least. If you adjust the difference by adjusting the connection on the bar, then you can no longer perform either of the mixer tests because the attachment points are no longer equal. How should I proceed?