New to foil kites and after watching every video under the sun I bought a Soul 1 the other day.
Short mixer test was grand
long mixer test on the left side was ok as well…
For some stupid reason I can’t find a point on the right side where A and Z markings are on the same level for the long mixer test
Any idea what I may be doing wrong?
Thank you for your help!
You can’t find point where A & Z have marking in same place because you probably connected front and back line in same place. These lines should be connected 10cm apart like they would be if you fly kite.
Get a piece of thin rope or dyneema. Tie a loop on one end and put a screw driver in the ground through the loop to secure it. Tie a knot on the end and connect one side of the bridles lines to it. Then tie a second knot under the first one about an inch under it. Connect the second line of that side and try and line them up. If still not able adjust that second knot up or down until they do. Job done.