Contact   Imprint   Advertising   Guidelines

Replacing wingding handles with DIY mini-booms

Forum for wing surfers
OzBungy
Very Frequent Poster
Posts: 2561
Joined: Fri Oct 21, 2005 11:35 am
Has thanked: 5 times
Been thanked: 152 times

Replacing wingding handles with DIY mini-booms

Postby OzBungy » Mon Nov 15, 2021 3:23 am

I posted this on the gear builder's forum, and put a link here in case DIY wingding people don't follow that forum.

viewtopic.php?f=107&t=2411699
OzBungy wrote:
Mon Nov 15, 2021 3:20 am
The foam inside the most used handles on a couple of my wingdings has compressed to be almost non-existent. The wings work quite will but it's a bit of a distraction having crushed webbing rubbing on some fingers.

It would be really easy to snip off the handles, leaving two tabs to sew onto, then put some carbon tube inside some tubular webbing and sew it on. I'm thinking one mini-boom would take the place of two handles.

Some questions:

Anybody tried this? How did it go?

The existing soft handles are about 15cm long. Rigid mini-boom handles would be about 35cm so the load transferred to the strut would change from two points 15cm apart to two points 35cm apart with a 25mm carbon tube stiffener. Would the wider attachment points compromise the structure of the strut? I'm thinking the carbon stiffener might make it more solid and lighter.

Return to “Wingsurfing”

Who is online

Users browsing this forum: No registered users and 4 guests