Glass hasn't cracked completely through on the top like it has on the base. Smaller one near the fin screw which hasn't cracked inside the hole luckily. Notice there's a faint crease on the base extending in from the crack - shitty photos, sorry.
Done a few surfboard repairs with epoxy resin, is it a similar process on twin tips? Been searching the forums & most people suggest epoxy for delaminations so I guess it's alright.
My question is should I sand down the crease on the top so the glass sits flat or just leave it alone since it hasn't cracked open & put two bigger layers of 6oz (all I've got at the moment) on the base to seal the crack & add strength. Dribbling some resin into the cracked rail also.
Greatly appreciate any ideas. Thanks