I have similar experiences with 80kg, but i didn’t lean in that much anymore because it doesn’t work, stay more upright, but push the board upwind a bit more.ice wrote: ↑Thu Mar 19, 2020 3:39 amI am talking about peak 4 versus lei wave kite on hydrofoil 1125 cm2, 90 kg rider. at lower end of wind range of kite
on the lei wave kite I could lean the board over and drive upwind
with a peak 4, if I lean, it kills the power of the kite (and I am not oversheeting)
I've used my peak4 5m with a TT board when the wind has come up and been too much for the foil. It works fine if you have enough wind.
Darippah,darippah wrote: ↑Fri Apr 03, 2020 4:12 amToday’s I was Riding my 4m p4 in low to mid 20’s on a race foil. Failed attempt at a back roll landed my foil in my lines. Kite crashed and no chance at relaunch.
Rolled up my lines in deep water sitting on my board, let the water out of the kite and set up for a hot launch. There was lots of wind chop / bay waves crashing on the kite but was able to unwind the lines with tension and keep the LE out of the water. Kite launched in no time
Who said P4 can’t water relaunch ?
I would say the process took about 10-15 minutes total.LeoLeal wrote: ↑Fri Apr 03, 2020 11:39 amDarippah,darippah wrote: ↑Fri Apr 03, 2020 4:12 amToday’s I was Riding my 4m p4 in low to mid 20’s on a race foil. Failed attempt at a back roll landed my foil in my lines. Kite crashed and no chance at relaunch.
Rolled up my lines in deep water sitting on my board, let the water out of the kite and set up for a hot launch. There was lots of wind chop / bay waves crashing on the kite but was able to unwind the lines with tension and keep the LE out of the water. Kite launched in no time
Who said P4 can’t water relaunch ?
How long does it take to setup the kite and hot launch again. Can you describe how to do it? It´s a very important tool to have.
Users browsing this forum: No registered users and 361 guests