Not enough tension to do mixer test, but just a way to get a well laid out photo without 8 hands.zob wrote: @jakemoore: I have to trie this tape on the wall method
I doubt the need for speculative mods, immediate tuning, 2:1 bars, non-standard different line lengths, rebuilding new mixer designs and removing entire bridle galleries to see it it becomes worth flying.
It’s easy to change with 2.5 mm amsteel actually and I gave done so on one of my Hyperlinks. I replaced the pullers with Harken rings. Hyperlink is a little different with rings but so far so good for me. The balance toward rings may change depending on how your sand is.
I agree with you, I did not know this problem when I wrote my initial review. But now I am a bit confused : I have a film of the waterstart trials, I do not like refrain from publishing tests ( I never do), but I know this kite may have not been setup correctly ; Ideally I should try a suitable Marabou now for better test and review , that would solve-out my "problem" ;
jakemoore wrote:I doubt the need for
jakemoore wrote:rebuilding new mixer
Flyfish wrote:Horrible mixer design
Bahahahahajakemoore wrote:It’s easy to change with 2.5 mm amsteel
Users browsing this forum: No registered users and 2 guests